Overview

A two pack varnish ideal for high traffic areas that receive severe abrasion such as gyms, dance floors or hallways. This heavy duty, hard wearing finish can be applied to interior timber flooring and worktops. Formulated to provide protection against spills, scratches and scuffing.

• Satin or gloss finish
• Slip and scratch resistant
• Hardwearing

Preparation

Always ensure the surface to be painted is clean, dry, and dirt free to ensure adhesion.

• Fill any minor defects, imperfections, or open joints with .
• Only use non-ferrous screws, nails, and fixings.
• Resinous deposits should be removed

New timber

• Newly laid timber flooring must be allowed to settle and adjust to the temperature for several days.
• Remove any remaining residues on the surfaces to be decorated.
• Machine-sand where applicable to make the surface smooth and remove irregularities.
• Finish with a fine-grade abrasive paper and vacuum clean the surface thoroughly.
• Degrease the exposed bare timber surface by wiping with a clean, lint free cloth, moistened with methylated spirits.
• If the wood requires staining apply only one coat of Sadolin Classic, which is low build, and allow to dry for 3-5 days

Previously coated surfaces

• Remove coating by using chemical strippers or sanding.

Application

We recommend always following the manufacturer's instructions found on the tin. Stir thoroughly, it is recommended that a small test area is applied before treating the entire surface to ensure compatibility.

• Apply with a soft bristle brush or short pile roller.
• When using a brush apply evenly and slowly to avoid the formation of air bubbles.
• When using a roller spread outwards from the point where the finish has been deposited. Then spread across at right angles to give an even build.
• Do not over-brush or roll.
• Allow the first coat to dry for 3-4 hours and lightly sand in the direction of the grain using a fine grade paper, P240 or finer.
• Remove dust and apply a second coat and third coat.